EPoX Computer EP-6VBA - Manual (Page 47)

BIOS
EP-6VBA
Page 4-19
Primary Slave UDMA:
This allows you to select the mode of operation for the hard drive.
The default is Auto.
Auto: The computer will select the optimal setting.
Disabled: The hard drive will run in normal mode.
Secondary Master UDMA:
This allows you to select the mode of operation for the hard drive.
The default is Auto.
Auto: The computer will select the optimal setting.
Disabled: The hard drive will run in normal mode.
Secondary Slave UDMA:
This allows you to select the mode of operation for the hard drive.
The default is Auto.
Auto: The computer will select the optimal setting.
Disabled: The hard drive will run in normal mode.
Init Display First:
If two video cards are used (1 AGP and 1 PCI) this specifies which one will be
the primary display adapter.
The default is PCI Slot.
PCI Slots: PCI video card will be primary adapter.
AGP: AGP video card will be primary adapter.
Onboard FDD Controller:
This controls the state of the onboard floppy controller. The default value is
Enabled.
Enabled: Enable the Onboard floppy drive interface controller.
Disabled: Disable the Onboard floppy drive interface controller.
Onboard Serial Port 1:
This field allows the user to configure the 1st serial port.
The default is Auto.
AUTO: Enable Onboard Serial port 1 and address is Auto adjusted
COM1: Enable Onboard Serial port 1 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 1 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 1 and address is 3E8H/IRQ4.