Sybase ADAPTIVE 15.0.2 - Manual (Page 119)

CHAPTER 7 Troubleshooting
Installation Guide 103
xhost: unable to open display "host_name"
To correct the problem:
1 Enter the following command at the UNIX prompt of your local machine,
where remote_machine is the machine on which you are running the
Installer:
xhost +remote_machine
2 Restart the Installer.
Address already in use
The following message from srvbuild means you entered a port number that is
already in use:
kernel: ninit: bind, Address already in use
To correct the problem, enter a different port number on the srvbuild window.
The command netstat -a produces a list of port numbers in use.
Adaptive Server fails to start
The shared memory of the operating system may not be set high enough.
To correct the problem, see Chapter 2, “Installing Adaptive Server” for
instructions on adjusting the shared memory value. Restart the installation or
upgrade process.
The Installer fails to start
If the Installer does not start, restart it, using:
"-is:javaconsole"
This displays any error messages to the console which user can then correct.
Cannot start XP Server
You may receive the following message from XP Server, when it is invoked by
xp_cmdshell or some other extended stored procedure: