El Paso Chile Company DMS 3080-80 - Manual (Page 2)

DESCRIPTION AND APPLICATIONS SPECIFICATIONS
PAGE 2
© copyright Paso Sound Products, Inc. 2002 Specifications are subject to change without notice DMS3040/3080/3120
Power Output:
DMS3040
DMS3080
DMS3120
Distortion:
Frequency Response:
Inputs:
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Sensitivity & Z:
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
AUX 1 Input
Attenuator:
AUX 2 Input
Attenuator:
Phantom Power:
Hum & Noise:
Telephone Paging Input:
Accessory Port:
EQ LINK:
Line Outputs:
Inputs/Outputs:
Subwoofer Outputs:
Subwoofer Output Level:
Music on Hold Output:
Zone 2 Output:
Zone 3 Output:
Main Output Impedance:
Controls:
Front Panel:
Rear Panel:
Bass and Treble Controls:
Tone By-Pass:
Remote Volume Controls:
MOH Source Selection:
Zone 2/3 Source Selection:
DUAL VOX:
VOX BUSS 1:
VOX BUSS 2:
MUTE BUSS 1:
MUTE BUSS 2:
MUTE 2 DELAY:
Unmuting:
Power Supply Output:
Auto VOX Relay:
Rack Mounting:
Internal Cooling Fan:
Power Requirement:
Power Consumption:
AC Accessory Outlet:
Terminations:
Housing Finish:
Output Power Indicator:
Dimensions:
Net Weight:
DMS3040
DMS3080
DMS3120
UNPACKING
Immediately upon receipt of the amplifier, inspect the unit
and shipping container for indications of improper handling
or in transit damage. The equipment was carefully inspect-
ed and tested before leaving the factory. Notify the
Transportation Company immediately if any damage is
found. ONLY THE CONSIGNEE CAN FILE A CLAIM WITH
THE CARRIER FOR DAMAGE DURING SHIPMENT. Be
sure to save the carton and packing material as evidence of
damage for the shipper inspection. DO NOT SHIP the unit
back to the factory unless authorized by the factory.
IN TRANSIT DAMAGES ARE NOT COVERED BY THE
PASO WARRANTY.
40 Watt RMS
80 Watt RMS
120 Watt RMS
Less than 0.5% THD
20 - 20,000 Hz ± 1 db
Microphone 1 Balanced
Microphone 2 Balanced
Microphone 3 Balanced
Microphone 4 Balanced - AUX 1
(Stereo Summing)
Microphone 5 Balanced - AUX 2 (Stereo Summing)
Telephone Interface - Transformer Balanced
Module Port
Mic 1 = 1.5 Mv - 250 ohm
Mic 2 = 1.5 Mv - 250 ohm
Mic 3 = 1.5 Mv - 250 ohm
Mic 4 = 1.5 Mv - 250 ohm - AUX 1 = 100 Mv - 47K
ohm
Mic 5 = 1.5 Mv - 250 ohm - AUX 2 = 100 Mv - 47K
ohm
Tel=100 Mv - 600 ohm - Transformer Balanced
Module= 1 V - 47K ohm
Variable (rear panel control)
Variable (rear panel control)
All Microphone Inputs by internal jumper (18 V)
Mic -70 db, Aux -75 db
600 ohm Transformer balanced
Accepts Standard Module
Preamp out, Power Amp in with EQ Link Switch
Line Out 600 ohm - 1.5 V loaded
MIX BUSS
Pre-EQ and Post-EQ Outputs
1 Volt
600 ohm-1 Volt Transformer Balanced
1 Watt-8 ohm with Control
1 Watt-8 ohm with Control
8 ohm, 25 Volt and 70 Volt line
Input 1 Level, Input 2 Level, Input 3 Level, Input 4
Level, Input 5 Level, Module Level, Bass and Treble
PHONE Level - AUX 1 Attenuator - AUX 2 Attenuator
- MOH/ZONE 1 Level Control - ZONE 2 Level Control
- VOX 1/VOX 2 Sensitivity - MUTE 2 Delay
± 10 dB at 100 Hz and 10 KHz
On - Off Switch
(rear panel)
AUX 1 Input Level and Master Volume (10 K)
AUX 1 - AUX 2 - MODULE by internal jumper
AUX 1 - AUX 2 - MODULE by internal jumper
Voice Activated Muting
Available on all 7 Inputs by internal jumpers
Available on all 7 Inputs by internal jumpers
Available on all 7 Inputs by internal jumpers
Available on all 7 Inputs by internal jumpers
Adjustable from 3 Sec to 30 Sec (rear panel control)
MUTES/UNMUTES MIC 1 only
24 V DC - 250 mA Regulated
NO/NC Contacts - VOX activated - Contacts Rating =
30 VDC - 7 A
Optional Model 27/3501 - 19” Rack Kit
3” Thermally Controlled -
Model DMS3120 only
117 Volt, 50-60 Hz
DMS3040 = AC = 630 VA - DMS3080 = 750 VA -
DMS3120 = 850VA Max.
500 W Max. Unswitched
Screw Terminals, RCA Jacks
Black
Multi-color LED
(front panel)
19” W., 12” D., 4” H. with feet (482X305X102 mm) 3.5”
H (89 mm). less feet
16 Lbs (8 Kg)
19 Lbs (8.5 Kg)
22 Lbs (11 Kg)
❑ ❑ High Performance - High Reliability Design
❑ ❑ Wide Frequency Response - Very Low Distortion
❑ ❑ 7 Channel Inputs - 3 Zone Outputs
❑ ❑ 5 Balanced Microphone Inputs
❑ ❑ Phantom Power on all MIC Inputs
❑ ❑ MIC 4/AUX 1 and MIC 5/AUX 2 Inputs
With Stereo Summing
❑ ❑ AUX1 and AUX2 Inputs Attenuator
❑ ❑ 600 ohm Transformer Balanced
Telephone Paging Input
❑ ❑ MIX Buss and 600 ohm Line Output
❑ ❑ Independent Input Controls
❑ ❑ Rear Panel Port: Accepts Standard Module
❑ ❑ Independent Module Level Control
❑ ❑ AUX1 and Master Remote Volume Controls
❑ ❑ External EQ Link
❑ ❑ Tone by-pass and EQ Link switches
❑ ❑ Pre-EQ Subwoofer Output
❑ ❑ Post-EQ Subwoofer Output
❑ ❑ Addressable Dual VOX Buss
Voice Activated Muting
❑ ❑ VOX Variable Time Delay Function
❑ ❑ Addressable Dual MUTE Buss
❑ ❑ Direct Muting and Unmuting
❑ ❑ 600 ohm and 8 ohm 1 Watt
Music on Hold Amplifier
❑ ❑ MOH Amplifier Source Selector
❑ ❑ Zone 2 and 3, 1 Watt - 8 ohm Output
with Separate Control
❑ ❑ NO/NC VOX Operated Relay
❑ ❑ 24 V DC 250 mA Regulated Power Supply Output
❑ ❑ 8 ohm, 25 Volt & 70 Volt Output
❑ ❑ Optional 19” Rack Mounting with Kit
❑ ❑ Low profile - 2-Unit of Vertical Rack space
❑ ❑ UL 6500 Listed (US - CANADA)
PROFESSIONAL AUDIO & SOUND
® TM
DIGITAL MUSIC SERIES
DIGITAL MUSIC AMPLIFIERS