Emerson CF730 - Manual (Page 8)

8
M5 x 6mm WASHER
HEAD SCREWS (3)
CAPTIVE SCREWS (2)
BLADE FLANGE
FAN
BLADE
Figure 9
10. Mount one blade flange to a fan blade
using three M5 x 6mm washer head
screws (supplied) (Figure 9). Repeat
this procedure for the four remaining
blades.
CAPTIVE
SCREWS (2)
BLADE
FLANGE
MOTOR
HUB
Figure 10
SWITCH HOUSING
BLUE WIRE
LIGHT
FITTER
BLACK
WIRE
SWITCH
HOUSING
WHITE
WIRE
LIGHT FITTER
LOOSEN THESE
THREE SCREWS
REMOVE AND
RETAIN THIS SCREW
WITH LOCKWASHER
LIGHT
FITTER
WHITE
WIRE
Figure 11
11. Position the blade flange on the motor
hub so that the captive screws in the
blade flange align with two threaded
holes in the motor hub (Figure 10).
Loosely tighten the captive screws at
this time. Repeat this procedure for
the remaining four blade assemblies.
12. Gently snug all captive screws to the
motor hug, working around the hub in
a clockwise sequence. Next, securely
tighten all captive screws, again
working in a clockwise sequence.
Failure to follow this procedure could
result in fan wobble. This completes
the blade installation.
15. Pass the reversing switch pull chain
through the hole in the light fitter
(Figure 12). Position the three
keyhole slots in the light fitter over the
three pan head screws in the switch
housing flange and turn the light fitter
clockwise.
13. Remove and retain the pan head
screw with lockwasher from the
recessed portion of the switch
housing flange (Figure 11). Loosen
the other three pan head screws in
the flange two or three turns.
14. Connect the white wire from the light
fitter to the white wire from the switch
housing (Figure 11). Connect the
black wire from the light fitter to the
blue wire from the switch housing.
Make sure both connectors are
securely engaged.
To avoid possible fire or shock, before
tightening the screws, make sure that the
wires are not pinched between the light
fitter and the switch housing flange.
Pinched wires will also cause the light
fitter to mount crooked on the switch
housing.
! WARNING
16. Tighten the three pan head screws
(Figure 12). Reinstall the pan head
screw with lockwasher (previously
removed) in the remaining hole to
secure the light fitter.
BP7315 Florissant 3/7/06 8:42 AM Page 8