Efficient Networks 5800 - Manual (Page 23)

Efficient Networks
®
5800 Series
User Reference Guide
Chapter 2: Easy Setup
Efficient Networks
®
Page 2-9
1. If you have selected PPPoE over RFC 1483 as your WAN protocol,
you will see a screen requesting a PPP user name and a PPP
password. You should have received this information from your
service provider. Enter your user name and password in the fields
indicated.
2. PPPoE Service Name requires the domain name of your network
service provider. The default entry is * (all services). Enter the
domain name of your network service provider in the Service Name
field.
3. PPPoE Timer will set a timeout interval for periods of inactivity.
After the number of seconds elapses, the PPP connection closes to
limit timed connection charges from your service provider. The
default value is “permanent” for unmetered service. To activate the
timer, enter the timeout interval (measured in seconds) into the
PPPoE Timer field.
4. PPPoE Only Filter will filter all traffic on the bridge to allow
PPPoE only. Check this box if you will only connect to your
network service using PPPoE.
5. Click on the Next button to continue Easy Setup.