Ecom Instruments Ex-CDMA 02 - Manual (Page 52)

5
Data settings
Setting Com port speed
The Com Speed sets the data rate at which your phone connects to a laptop
or PC, or at which it sends and receives over-the-air text messages.
. Select Menu ‡ Settings ‡ Accessories ‡ Com Speed.
2. Select the speed. The options are: 19.2 kbps,115.2 kbps (default), 230.4
kbps.
Note: There may be a higher charge for making calls using high-speed data
in areas where X service is available.
Setting the phone to receive data or faxes
Your phone may be able to receive certain data or faxes, depending on the
system sending the information. To receive data or faxes, you must connect
the phone to a laptop or PC and switch the phone from voice mode to
data/fax mode.
. Connect the phone to the laptop or PC.
2. Set the Com Speed.
3. Select Menu ‡ Settings ‡ Network ‡ Data/Fax Calls.
4. Press
to select an option:
- Voice only - Allow only voice calls.
- Fax, next call or Data, next call - Set the phone to fax mode or data
mode for the next incoming call or the next 0 minutes.
- Fax, until off or Data, until off - Force the phone into fax mode or data
mode until the phone is turned off.
Note: You cannot receive voice calls while the phone is in data/fax mode.
Connecting to a TTY/TDD device
You can connect the phone to a TTY device for the hearing impaired.
Note: Enable TTY only when using the phone with a TTY device.
. Connect the TTY device to the phone.
2. Enter
from your keypad.
3. Press to select the TTY option.
Setting position location
This setting allows you to share your location information with network ser-
vices other than emergency services (9, , 000, etc.), in markets where
service has been implemented.
Note: This feature works only when your phone is in digital mode. You do not
have the option of turning off the locator to emergency services.