Eltax Cinema DVD Home Theatre System Vision DVD Home Theatre System - Manual (Page 12)

This well-designed DVD receiver provides
optimum sound quality when the speakers used
are within the range of their rated impedance.
Important
The minimum impedance of the five speaker
terminals is 4 ohm; for the subwoofer, it is
8 ohm.
If you want to use only one speaker or listen
to monophonic music, do not parallel connect
individual speakers to the left and right
channel terminals. See the figure on the left
below.
Connecting Speaker Cables
1.Peel off approximately 1/ 2 of cable
insulation
2.Tighten the wire end (#2 below)
3.Open cable terminal by pressing back on
tab
4.Insert wire end into terminal
5.Release tab; make sure wire is in terminal
securely
Note: To prevent damage to the circuit, care
should be taken to prevent short circuiting from
occurring at the positive and negative poles of
the speaker cord.
"
CONNECTING
SPEAKERS
11
230V ~50Hz
OPTICAL OUTPUT OUTPUT
L L SW SW COAXIAL
S-VIDEO VIDEO R
1 2
3 4 5
Surround-speaker Surround-speaker
Front-speaker
Front-speaker
Center-speaker
Subwoofer