Eva Solo LX-90TM - Manual (Page 12)

Open the pin feed covers as shown on the previous page and feed
the paper under the paper separator and into the paper slot. Push the
paper through until it comes up between the ribbon guide and the
platen. Pull the paper up until the top is above the pin-feed holders; fit
the holes on the left side of the paper over the pins in the left holder;
then close the cover.
Fit the right side of the paper in the right holder, moving the holder
as needed to match the width of the paper. Close the second cover,
making sure the paper has no dips or wrinkles; then lock the right
holder in place with the locking lever. Push the paper bail against the
paper.
Now you are ready to set the top of page position.
Turn the paper feed knob to advance the paper until a perforation
between sheets is approximately l/8 of an inch below the top of the
ribbon guide, as shown in the illustration.
When you turn on your it remembers this top of page setting
and uses it when any program (or the FF button) tells it to move to the
top of the next page.
9