Eva Solo LX-90TM - Manual (Page 7)

To install or replace the ribbon, just follow these steps:
Caution
If you’ve been using your printer just before you change rib-
bon cassettes, be careful not to touch the print head because it
becomes hot during use. Also remember never to move the
ribbon carriage manually when the printer is turned on,
because you may damage your printer.
1.
Make sure the printer is turned OFF. Remove the front lid of the
printer so that you can see the ribbon carriage.
2. Slide the ribbon carriage manually to the center of the printer so
that the other parts of the printer do not get in your way. Also be
sure that the paper bail is against the black roller.
3. If you are changing ribbon cassettes, lift the front of the old cassette
and remove it.
4.
Hold the new ribbon cassette so that the small knob is on top and
the exposed ribbon faces away from you. Fit the cassette onto the
ribbon carriage by sliding the pins at the back of the cassette under
the small hooks on the carriage.
Paper
Pin
4