Emerson HK250 - Manual (Page 14)

14
BASIC OPERATION (CONTINUED)
REDIALING A NUMBER
Press the TALK button ❶ (the light will
come on), followed by the REDIAL
button ❷ to automatically redial the
last number dialed on this handset (up
to 32 digits).
NOTE: Please note that only the last
number you called on this handset can
be stored in the Redial memory.
2
1
1
ENDING A CALL
To end a call, simply return the
handset to the base, or press the
TALK button on the handset; the light
will go off.
1
ADJUSTING EARPIECE VOLUME
To adjust the volume in the earpiece,
press the TALK button ❶ and the light
will come on. Then, press the REVIEW/
VOLUME /❷ buttons ❷ until the
desired volume level is reached.
2
1
2
1
CHANNEL SELECTION
The base unit will automatically search for
the clearest channel in the Standby mode.
However, should you hear static or noise
during the course of a conversation which
makes it difficult to hear the caller, the CHN
(Channel) button on the handset allows you
to choose between 40 preset channels.
NOTE: The TALK LED will flash and the unit
will sound two beeps to indicate the unit is
changing to another channel. The unit will
sound an error beep and return to the original
channel if it cannot reach a clearer channel.
1
OUT OF RANGE WARNING
The handset and base communicate up to a maximum range. The distance can
be affected by the weather, power lines or other cordless telephones. You are out
of range and should move closer when:
• You hear noise or static.
• Pressing the TALK button generates three short beeps.
• Pressing the CID button when a number is displayed generates three short
beeps.
• You cannot receive an incoming call.
HK250.O/M.QXD 9/26/02 3:49 PM Page 14