EverFocus EDVR SERIES - Manual (Page 40)

N.C. Trans.: When the alarm is triggered, buzzer, alarm output and alarm recording
start to function no matter how long the alarm duration is set until you set it back to N.C.
3. LOG
YES: Select YES if you wish to record Alarm Events in the Log.
NO: Select NO if you do not wish to record Alarm Events in the Log.
4. ACTIVE CAMERA
This field is to activate camera you want to have the alarm enabled too. For example if
you had an external motion detector on camera one you would set this option to camera
one. The Default from the factory is set to on. To change this, simply use the Jog Dial on
the DVR.
Active camera setting, from camera 01~16. You can set the camera which
corresponds to the place where the alarm is located.
5. PTZ PRESET
Select PTZ PRESET from “001” to “255”, so that when Alarm occurs, speed dome will
turn to this preset position for event recording. This function improves surveillance
quality of an alarm event. If you wish to disable this function, please simply select
“OFF”.
6. DURATION
The amount of time an alarm event will record - from 1 sec to 99 seconds. The default
value is 5 seconds.
7. ALARM OUTPUT
This will transmit a signal to another device. The setting of alarms are NONE = not
activated, 1 = output signal 1 transmitted, 2 = output signal 2 transmitted, 3 =
output signal 3 transmitted and 4 = output signal 4 transmitted.
Note: For D1 and D2 series, it has only 1 alarm output. For D3 series, there are totally
4 alarm outputs.
8. ALARM EMAIL
Select “YES” for sending an email when alarm occurs. The email address can be set in
the NETWORK SETUP MENU.
9. BUZZER: Audible alarm buzzer.
ENABLE: To enable an alarm buzzer.
DISABLE: To disable an alarm buzzer.
30