Eclipse - Fujitsu Ten AVN7000 EN - Manual (Page 10)

- 10 -
Notes on installation
• • Check the vehicle speed pulse signal, parking brake signal, and reverse signal carefully before making
the connections. If the cables are incorrectly connected, accidents or problems with correct operation
may result.
• • The label on the vehicle speed pulse signal cable contains a protection circuit, so do not cut the cable
or remove the protective circuit, otherwise problems with operation may result.
• • Bind the cables together with tape so that they do not cause an obstruction while driving. If they
become wound or entageled around parts such as the steering wheel, shifting lever, or brake pedal,
accidents may result.
The locations where the vehicle speed pulse signal cable, parking brake signal cable, and reverse cable
may vary depending on the vehicle model and grade. Ask the car dealer or your nearest Eclipse dealer
for details.
Tip
Connecting the v Connecting the v ehicle speed pulse ehicle speed pulse , par , par king king
br br ak ak e e , and re , and re v v erse cab erse cab les (wires) les (wires)
- A connecting point for the vehicle speed pulse signal (example) -
Vehicle speed pulse
signal cable (vehicle harness)
Engine computer
Vehicle speed pulse
signal cable
(purple/white) of
connection cable
Contains a protective circuit
so never remove.
Splicing connector
Always be sure to connect the vehicle speed
pulse, otherwise the measurement precision will
be greatly reduced.
Tip
10
Use a splicing connector to connect the vehicle
speed pulse signal cable (purple/white) coming
from the main unit to the vehicle speed pulse
signal cable of the vehicle. 1
Route the vehicle speed pulse signal cable to the
main unit. 2