Eclipse - Fujitsu Ten AVN7000 EN - Manual (Page 20)

- 20 -
090003-28540700
0508DE (CN)
“ECLIPSE” is a registered trademark of
FUJITSU TEN LIMITED in 48 countries
including the U.S. and Japan.
Remove the pocket and any other accessories
from the center cluster to make room for the main
unit.
1
Remove the mounting brackets for the pocket.
2
Mounting bolts
Pocket, etc
Center cluster panel
Attach the brackets to the main unit. 3
Install the main unit in the vehicle. 4 Main unit
Mounting bracket
1
Connect all cables before installing the main
unit.
Tip
Be careful not to forcefully push on the main unit's
display or buttons during installation. This may
result in damage to the main unit.
Tip
6
5
4
Install the bezel on the main unit.
Fasten the rear of the main unit.
Insert the main unit into the mounting sleeve until
it locks in place.
-Mounting the main unit (If installing the main unit using the side brackets of the vehicle)-
Bezel 6
Mounting sleeve 7
Metal of vehicle
Dashboard or console box
Be sure to use the supplied accessory mounting
screws (M4 x 5) as the mounting screws. If any
other screws are used, they may damage the
inside of the unit.
Tip
example 2
By adjusting the positions of the brackets, the
main unit's installed depth can be adjusted.
example 1
Front of vehicle Front of vehicle
Pocket
(M4 x 5) x 4
12
Screws x 2
Screw position Screw position
If using these installation holes, be sure to use
the Pan screw with washer (Blue:M4 x 3).
Main unit 1 Main unit 1
13