Setting up and connecting, Inserting the battery, Mounting under a wall cupboard – Silvercrest SKRD 30 A1 User Manual

Page 11

Advertising
background image

9

Setting up and connecting

SKRD 30 A1

GB

Inserting the battery

By inserting the battery you can avoid the loss of programmed time of day and
alarm times in the event of a possible power outage. The battery ensures that
the internal clock continues to run even during a power failure. When power is
restored the correct time appears automatically in the display

3

.

NOTICE

The device can also be operated without a battery.

Open the cover of the battery compartment

19

on the underside of the

device by turning the cover to the left, with a coin, as far as it will go and
then lift off .

Insert the battery type CR2032 (supplied) into the battery compartment.

The side with the marking + points upwards.

Close the battery compartment by attaching the cover and then with a coin

turn it to the right.

Mounting under a wall cupboard

(Illustration see fold out side fi gure B)

With the supplied mounting plate

you can mount the device under, for exam-

ple, a wall cupboard. For mounting of the device proceed as follows:

Press both unlocking buttons

20

on the rear panel of the device downwards

thereby, at the same time, sliding the mounting plate

backwards and

remove the mounting plate

.

Find a suitable set-up location for the device (see also the section

Requirements for the set-up location).

Hold the mounting plate

under the set-up location. Thereby the front

edge of the mounting plate

should be approx. 4 cm behind the front of

the cupboard so that, after Remove the mounting, the device is fl ush with the
cupboard.

Mark the 4 fastening points with a pencil.

Using a spike or nail, make a small depression at the respective marking

points. Screw the mounting plate

tightly with the supplied screws as

illustrated in fi gure B.

Place the device aslant, with the front recesses in the top face, in the mount-

ing plate

. Press the rear part of the device upwards against the mounting

plate

until the device audibly locks into place.

Check to make sure that the device is secure.

Advertising