Handling and operation, Radio operation, Switching the radio on/off – Silvercrest SKRD 30 A1 User Manual

Page 21: Adjusting the volume, Manual station selection, Search for the next station

Advertising
background image

19

Handling and operation

SKRD 30 A1

GB

Radio operation

NOTICE

For a good radio reception the wire antenna

15

must be completely un-

coiled. Adjust the antenna, whilst in radio operation, to the best reception.

The technical factors of the device allow for tuning reception frequencies

outside of the permitted VHF (FM) range of 87.5–108 MHz. In some
countries, diff erent national regulations may apply to the assigned radio
frequency ranges.
Please note that information received outside of the assigned radio
frequency ranges may not be exploited, passed on to third parties or
otherwise misused.

Switching the radio on/off

Switch the radio on by pressing the On/Off

4

button.The display

3

shows the current reception frequency of the tuned station.

Switch the radio off by pressing the On/Off

4

button again.The device

changes back to the operational mode clock/standby operation. The cur-
rent time of day is shown.

Adjusting the volume.

With the VOLUME

14

knob set the desired volume. Turning in a clockwise

direction increases the volume; turning in a counter clockwise direction
reduces the volume. The volume level is shown on the left border of the
display

3

.

Manual station selection

By a single press on the buttons Tune+

13

and Tune–

12

tune the desired

station. The frequency of the station is shown in the display

3

. During the

tuning the speaker is switched off .

Search for the next station

The device can automatically search for the nearest station.

Press and hold down the button Tune+

13

or Tune-

12

for at least two seconds.

The device searches for the nearest station with suffi cient reception quality.

Repeat this process until you have found the station you are looking for.

Advertising