Silvercrest SKRD 30 A1 - Manual (Page 20)

18
Handling and operation
SKRD 30 A1
GB
Waken with radio
If you want to be woken by the radio, before activating the wake time carry out
the following settings:
Switch the radio on by pressing the On/Off ♦ 4 button.
Select the station with which you want to be woken (see section ♦
Station setting).
With the VOLUME ♦ 14 knob set the desired volume (see section
Volume settings).
Switch the radio off by pressing the On/Off ♦ 4 button.
To select "Radio" for the respective alarm press the Alarm1 button ♦ 8 or the
Alarm2 button 9 several times in succession until, in the display 3 , the
symbol appears.
Switching the alarm off
Prerequisite: The device is in the operational mode clock/standby operation.
To switch off the respective alarm press the Alarm1 button ♦ 8 or the Alarm2
button 9 several times in succession until no symbols are shown in the
display 3 .
When the wake time has arrived
With the setting "Wake with alarm tone" a fourfold signal tone sounds in
intervals of 2 seconds. The volume of the signal tone will continually increase
until the maximum volume has been reached. The duration of the wake signal is
restricted to 10 minutes.
With the setting "Wake with radio" the radio will switch on. The previously
selected station will be activated for a maximum of 60 minutes at the set volume.
Press the button Snooze/Timer ♦ 14 to activate a repeat wake after 9 minutes.
NOTICE
The repeat wake function is possible up to 60 minutes after the set wake ►
time has arrived.
Press the Alarm1 button ♦ 8 or the Alarm2 button 9 to end the current
alarm.
NOTICE
The alarm becomes active again when the next wake time has arrived ►
(i.e. on the next day).