Emerson Liebert XDCF - Manual (Page 10)

Mechanical Considerations
6
3.0 M
ECHANICAL
C
ONSIDERATIONS
The Liebert XDCF is engineered to fit on the rear of the Egenera BladeFrame enclosure. Figure 5,
below, illustrates the unit’s dimensions and the location of pipes. Figure 6 shows the attachment
positions of each module.
Figure 5 Overall dimensions
R-134a
RE TURN
ONCE FLE X P IP E CONNE CTIONS
ARE MADE TO THE UNIT DO NOT
DIS AS S E MBLE FROM THE UNIT .
RE MOV E CONNE CTIONS FROM
CE ILING HE ADE RS BY TURNING
THE S UP P LY V ALV E TO THE
OFF P OS ITION AND THE N TURNING
THE RE TURN V ALV E TO THE OFF
P OS ITION THE HE ADE R
CONNE CTIONS MAY BE RE MOV E D.
S UP P LY
1194311 P1
7-3/8"
(187mm)
1-5/8"
(41mm)
3-3/4"
(95mm)
TIGHTE N FLE X P IP E
TO UNIT WITH THE
S CHRADE R V ALV E
IN THIS P OS ITION
TIGHTE N FLE X P IP E
TO UNIT WITH THE
S CHRADE R V ALV E
IN THIS P OS ITION
13-3/8"
(340mm)
30-1/4"
(768mm)
7/8" (22mm)
EMERSON
NETWORK POWER
Liebert
XD
TM
3-3/4"
(95mm)
1-5/8"
(41mm)
T M
BACK
TOP
RIGHT
SIDE
Upper unit shown;
both upper and
lower units have
same dimensions
Return
Pipe
Piping is not load-bearing
and should never be used
to lift or move the Liebert
XDCF
FRONT
DISCHARGE
SIDE