Emerson Liebert XDCF - Manual (Page 9)

General product information
5
2.6 Unpacking the Liebert XDCF
The unit is shipped in a protective package. Do not remove the packaging from the Liebert XDCF
before it is at the installation location.
• When unpacking and handling the Liebert XDCF, care should be taken to prevent damaging the
coils.
• Remove outer packaging when ready to install the Liebert XDCF.
• Do not use unit piping to lift or move the Liebert XDCF.
2.6.1 Recyclable Packaging
All material used to package this unit is recyclable. Please save for future use or
dispose of the material appropriately.
NOTICE
Risk of unit damage if improperly stored. Keep the unit indoors and protected from dampness,
freezing temperatures and contact damage.
Figure 4 Unpacking the Liebert XDCF
!
CAUTION
Risk of sharp edges, splinters and exposed fasteners! Can cause personal injury!
Only properly trained personnel wearing appropriate safety headgear, gloves, shoes and
glasses should attempt to move, lift, remove packaging from, or prepare unit for installation.
R
Unit Ref.
3
Coil End
Mounting Assembly
3
1
5
4
1
2
2
Notes
Area indicated on Item #3 (foam insert) is to be used
for hardware kit and/or unit manuals for shipping to customer.
Coil end mounting assembly is to be wrapped in P/N 123783P1
(bubble) and placed into Item #2 (corrugated insert), only when
packaging a specified bottom-mount unit.
3. Ref: Use P/N S-6060, or equivalent adhesive, to seal the top and
bottom of Item #1 (box) for shipping to the customer.
4. Refer to manufacturing work instructions for any additional
directions regarding packaging of this unit.
2.
1.
182713