Silvercrest SHSS 12 B2 - Manual (Page 10)

7 SHSS 12 B2
GB
Operation
ATTENTION! MATERIAL DAMAGE!
► The suction opening must always be open and
unblocked. Blockages lead to overheating and
damage to the motor.
► Do not vacuum shag pile carpet with the fl oor
nozzle. The rotary brush r can get caught in
the carpet and block!
NOTE
► Make certain that the dust fi lter 6 and the
coarse fi lter 7 are always inserted before
using the appliance.
► As soon as the suction power of the appliance
begins to diminish noticeably, connect the
appliance to the charger i.
Using the hand element with the
handle
1) Insert the hand element 4 into the hand
element recess e as described in the chapter
"Assembly/disassembly".
2) Fold out the grip 0 by pressing the "Grip"
release q and at the same time pulling the
grip 0 upwards.
3) Switch on the appliance using the on/off
switch 9. The LED lamp t on the fl oor nozzle
will illuminate and the rotary brush r starts
turning.
4) Guide the fl oor nozzle over the area to be
vacuumed. Hold the grip 0 so that the fl oor
nozzle moves smoothly over the fl oor.
5) Press the on/off switch 9 when you have
fi nished vacuuming. The rotary brush r stops
and the LED lamp t goes out.
Using the hand element
1) Remove the hand element 4 from the hand
element recess e as described in the chapter
"Assembly/disassembly".
2) If required, attach the crevice tool u or the
brush nozzle z.
3) Set the on/off switch 2 to start vacuuming the
desired areas.
4) When you have fi nished vacuuming, press the
on/off switch 2 again.
Cleaning and care
WARNING! RISK OF INJURY!
► Always disconnect the charger i from the
mains socket and remove the barrel jack o
from the charging socket s on the cradle d
before cleaning the cradle d.
► Always remove the hand element 4 from the
hand element recess e on the handle before
cleaning the hand element 4, the handle or
the rotary brush r.
To achieve the best results, empty the dirt container
8 and clean the dust fi lter 6 after every use.
ATTENTION! MATERIAL DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
NOTE
► The LED lamp t is maintenance-free.
The LEDs cannot be changed.
IB_100116_SHSS12B2_LB4.indb 7 19.09.14 13:49