Silvercrest SHSS 12 B2 - Manual (Page 11)

8 SHSS 12 B2
GB
Emptying the dirt container
1) To open the dirt container 8, remove the hand
element 4 from the hand element recess e.
2) Press both buttons 5 and, at the same time,
pull the dirt container 8 upwards.
You can now lift this off upwards/forwards.
3) Remove the dust fi lter 6 by pulling it out with
your fi ngers. Rinse the dust fi lter 6 in clear
water and let it air dry. Do not use hot air to
dry the dust fi lter 6.
4) Then remove the coarse fi lter 7 also by simply
pulling it out.
Fig. 3
5) Empty the dirt container 8.
6) Now you can re-insert fi rst the coarse fi lter 7
and then the dust fi lter 6.
7) Replace the dirt container 8 by fi rst inserting
the catch into the notch in the hand element 4
and then pushing the front part of the dirt con-
tainer 8 fi rmly downwards so that the dirt
container 8 clicks fi rmly into place.
Cleaning the appliance
Wipe the appliance with a damp cloth. For stubborn
dirt, wipe, adding mild detergent to the cloth.
Ensure that the appliance is completely dry before
the next use.
Cleaning the rotary brush
The rotary brush r can become covered in
residues, such as hair, after a while. To remove this
dirt, you can remove the rotary brush r (Fig. 4).
1) Turn the fl oor nozzle upside down.
2) Push the catch on the cover plate to the rear
so that you can remove the cover plate.
3) Lift out the rotary brush r.
4) To replace the rotary brush r, fi rst push the
broad end onto the drive shaft so that the
rotary brush r hooks into place.
5) Then push the other end into the mount so that
the rotary brush r sits straight in the fl oor
nozzle.
6) Replace the cover plate and fasten it fi rmly into
place.
Fig. 4
IB_100116_SHSS12B2_LB4.indb 8 19.09.14 13:49