Silvercrest SGT 10.6 A2 - Manual (Page 33)

SilverCrest graphics tablet SGT 10.6 A2
English - 31
Cleaning / maintenance
The device must be repaired if fluid has penetrated inside the housing, if the housing is damaged or
if it no longer works.
Never open the graphics tablet. Any repairs should be carried out exclusively by qualified
specialist, service or maintenance personnel.
Always disconnect the device from the computer before cleaning it.
The device must be kept clean at all times, especially the active area. Reliable function of the device
is not ensured if the active area is soiled.
If soiled, clean the device with a dry cloth, and moisten the cloth slightly to remove stubborn dirt. Do
not use any solvents, corrosive or gaseous cleaning agents. Ensure that no moisture penetrates the
device.
Disposal of old devices
The Waste Electrical and Electronic Equipment Directive (WEEE) 2002/96/EC
stipulates that it is no longer permitted to dispose of old electrical and electronic
devices as municipal waste. Please only dispose of this product at a collection
point for old devices in your area.
The correct disposal of old devices in this manner will prevent environmental pollution and human
health hazards.
Remember to protect the environment. Used batteries should not be disposed of in domestic waste.
They must be taken to a collection point for old batteries. Please note that only discharged batteries
may be deposited in collection bins for portable batteries. Care must be taken to ensure that
batteries that are not fully discharged do not short circuit.
Conformity information
This product conforms fully to the basic requirements and other required provisions of the EMC
Directive 2004/108/EC. The Declaration of Conformity can be found at the end of this manual.