Silvercrest SGR 150 B1 - Manual (Page 10)

Electric food grater SGR 150 B1
8 - English
Description of the controls
For safety reasons, the Start button (2) must be pressed and held to operate the electric food grater
(1). As soon as you release the Start button (2), the electric food grater (1) switches itself off.
Prior to use
Remove the electric food grater SGR 150 B1 and all accessories from the packaging and check
that all items have been included. Remove all protective foil. We recommend that you clean all
accessories again prior to their initial use.
Inserting/removing cylinder
Select one of the 5 enclosed cylinders (4, 5, 6, 7, 10) as required and insert it into the feed chute
(11). For the range of application of the individual cylinders (4, 5, 6, 7, 10), please refer to the
diagram in the "Cylinders" section on page 10. Then attach the feed chute (11) with the inserted
cylinder (4, 5, 6, 7, 10) to the motor shaft (9). To facilitate this attachment, an arrow () is
indicated at the back of the feed chute (11). On the housing of the food grater (1), an open lock
is indicated on the right next to the motor shaft (9) and a closed lock
H
is indicated above it.
Proceed as follows:
 Attach the feed chute (11) with the inserted cylinder (4, 5, 6, 7, 10) to the motor shaft (9) so
that the arrow () on the feed chute (11) points towards the open lock on the housing of
the food grater (1).
 Then rotate the feed chute (11) anticlockwise until the arrow () points to the closed lock
H
on the housing of the food grater (1).
Store the remaining cylinders (4, 5, 6, 7, 10) in the storage compartment (8) and close it with the
storage compartment cover (3). Then attach the storage compartment (8) to the electric food grater
(1).
To facilitate the closing of the storage compartment (8), an arrow () is indicated on it
and on the storage compartment cover (3). When closing the compartment, the arrows
must lie more or less opposite each other ().
To facilitate the attachment of the storage compartment (8), an arrow () is indicated
on it and behind the Start button (2) on the electric food grater (1). When attaching the
compartment, the arrows must lie more or less opposite each other ().
To remove the cylinder, first remove the feed chute (11) from the food grater (1).
 Then rotate the feed chute (11) clockwise until the arrow () points to the open lock on the
housing of the food grater (1).