Silvercrest SEAD 1800 A1 - Manual (Page 9)

7 SEAD 1800 A1
GB
Setting up and connecting to the mains
power supply
Unpacking
Remove all parts of the appliance and the operating instructions from the ♦
packaging.
Remove all packing material. ♦
Disposal of the packaging
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The return of packaging into the material circuit saves on raw materials and
reduces the amount of generated waste. Dispose of the packaging material that
is no longer needed as per the locally established regulations.
NOTICE
If possible retain the appliance's original packaging during the warranty ►
period, so that, in the event of a warranty claim, you can ideally pack the
appliance for its return.
Appliance set up and making ready for use
Completely unwind the power cable from the cable storage ■ 8.
Place the appliance on a level and slip-free surface. Ensure that a mains ■
power socket is easily accessible.
Clean the appliance as described in the chapter “Cleaning and Care”. ■
Insert the plug into a mains power socket. The display lights up, a signal tone ■
is heard.
WARNING - PROPERTY DAMAGE!
NEVER operate the appliance in a no-load condition! The appliance ►
could be irreparably damaged!
WARNING - RISK OF INJURY!
When it is hot, take hold of the appliance ONLY by means of the heat ►
insulated handles 2. Risk of Burns!
Fill the appliance with about 5 liters of water and allow it to boil for 20 ■
minutes (see the section “ Switching the appliance on and off ”). After it has
boiled, pour this water away.