Silvercrest SRR 800 A1 - Manual (Page 48)

SilverCrest SRR 800 A1
46 - English
Charging the battery
The shaver is equipped with a high-performance NiMH battery. You can
charge it with the supplied mains charger and USB cable.
The shaver must be switched off before it is charged. Thus check in
advance whether the shaver is switched off and, if necessary, push
the on/off switch [6] downwards to switch off the shaver.
To extend the built-in battery life, we recommend that you discharge
the battery fully before recharging it. The performance of the shaver
deteriorates or the shaver stops once the battery is fully discharged.
To charge the battery, connect the small connector of the supplied USB
cable to the USB port [9]. Then connect the large connector of the
supplied USB cable to the mains charger. Insert the charger into a mains
socket. The power indicator [8] now lights up red and thus indicates that
the shaver is connected to the mains power supply. A full charge cycle
takes approximately 8 hours. Then unplug the charger from the mains
socket to save energy. Separate the USB cable from the charger and the
shaver.
You can also charge the shaver directly via a USB port on your
computer. In this case, connect the large connector of the supplied
USB cable directly to the USB port on your computer instead of
connecting the mains charger.