Silvercrest SRR 800 A1 - Manual (Page 51)

SilverCrest SRR 800 A1
English - 49
Maintenance
Replace the shaving foil [2] and the cutter block [4] if they show signs of
wear and tear. The shaving foil [2] and cutter block [4] should both be
replaced at the same time for optimal shaving results.
You can obtain information on spare parts via our service hotline (see
page 55). To facilitate replacement, the shaving foil [2] is only available
with the shaving foil frame [3].
Before replacing the shaving foil [2] and the cutter block [4], unplug
the shaver from the mains power supply as there is a risk of an
electric shock!
CAUTION! RISK OF INJURY!
Switch off the shaver before replacing the shaving foil [2] and the
cutter block [4].
Do not press the shaving foil [2] as this can be easily damaged and
sharp cut edges can arise as a result.
Only grip the cutter block [4] at both ends.
Proceed as follows to replace the shaving foil [2] and the cutter block [4]:
Remove the protective cover [1]. Press both sides of the release [5] and
remove the shaving foil frame [3]. Grip the cutter block [4] at both ends
and pull it upwards. Put the new cutter block [4] and then the new shaving
foil frame [3] on again. Then put the protective cover [1] on again.