Silvercrest SRR 800 A1 - Manual (Page 49)

SilverCrest SRR 800 A1
English - 47
Some computers turn off the power supply of the USB ports when
they are switched off. If the power indicator [8] of the shaver does
not light up, make sure that your computer is switched on.
First use
Only use the shaver for dry shaving.
Remove the protective cover [1]. Press the switch guard [7] and push the
on/off switch [6] upwards to switch on the shaver. Move the shaver over
your skin while exercising slight pressure against the direction of facial hair
growth. Always hold the shaver at a right angle to the skin. You can also
hold the skin taut with your other hand to raise your facial hair.
Please note that there may be a slight redness or irritation of the skin
after shaving. This is quite normal because your skin must first get
used to this manner of shaving. It may take two to three weeks for
your skin to get used to the shaver.
Switch off the shaver after shaving by pushing the on/off switch [6]
downwards. After using the shaver, put the protective cover [1] back on
the shaving foil frame [3]. Clean the shaver as described in the following
section.