Elation Professional 70 - Manual (Page 21)

DESIGN Brick 70™
©Elation Professional, Los Angeles Ca. 20 www.ElationLighting.com
controller.
8.1.4 Auto Program
This function allows the internal programs to run in either stand-alone or master/salve
mode. In “Master” mode the fixture will send DMX data to other fixtures connect via the
DMX chain. In “Alone” mode the fixture will operate as a single fixture. The program for
this mode is selected in the “Select program” section of the control menu. You can set
the number of steps under “Edit program”. You can edit the individual scenes under
“Edit scenes”. With this function, you can run the individual scenes either automatically,
i.e. with the adjusted Step-Time.
8.2 Information:
8.2.1 Time information
These functions will detail different time functions associated with the fixture.
Current Time
This function displays the running time of the fixture from the last power on. The
display shows “XXXX”, where “XXXX” represents the number of hours the fixture
has been running. This counter is automatically reset after every power-on.
Total Life Hours
This function tracks the total running time of the fixture from the very first start-up.
Where “XXXX” represents the total number of running hours. This time is none
destructive and will remain in the fixtures memory indefinitely.
Last Run Hours
This function tracks the number of hours the fixture was operating on it’s previous
cycle. Where “XXXX” represents the number of hours. This counter is automatically
reset after every power down.