Elation Professional 70 - Manual (Page 24)

DESIGN Brick 70™
©Elation Professional, Los Angeles Ca. 23 www.ElationLighting.com
8.4 Manual Control –This function allows the LEDs to be set manually without the use of
an external controller
8.5 User Mode Set:
8.5.1 User Mode - This function allows the DMX channels assignment to be changed
from the default value of 5, to either 35 channels or extended mode at 4
channels, 5 channels, 8 channels and 11 channels. This function also allows the
user to create user defined channel orders allowing the fixture to match the
channel order of other fixtures on the market for easier operation. A total of three
user modes may be configured.
8.5.2 Pixel grouping – This function allows the Pixel grouping to be set per a cell.
Select from 001 to 007.
8.6 EDIT PROGRAM: - The fixture comes equipped with a built-in DMX recorder that allows
custom programs to be installed and recalled directly from the fixture’s control board.
Programs can be created and stored using the fixture’s control board or by using an external
DMX controller.
8.6.1 Select program – This function allows the user to select one of ten of the user
defined built-in programs. This program is then accessed in “Function Mode”
under “Program Run.”
8.6.2 Edit program – This function allows the user to edit the built-in programs.
8.6.3 Edit Scenes – This function allows the user to edit or define the actual scenes
that are stored in the user defined built-in programs that are accessed in the
previous step.
8.6.4 Rec Controller - The Design Brick 70 ™ features an integrated DMX recorder.
Pre-programmed scenes can be transmitted to the fixture via any DMX compliant
controller. This function allows those scenes to be stored in to the fixture’s built-in
memory and then subsequently used to create the user-defined programs.