Silvercrest SHBS 5 A1 - Manual (Page 12)

9 SHBS 5 A1
GB
Before fi rst use
The hair and beard trimmer can be used as a battery-powered or mains-powered appliance.
Charging the batteries
The battery for the hair and beard trimmer should be charged for at least 90 minutes before fi rst use.
♦ Connect the mains power adapter cable 6 to the hair and beard trimmer charging station 5 .
♦ Avoid damaging the appliance! Ensure that the appliance is switched off before charging the
battery.
♦ Plug the mains power adapter 6 (wide-range voltage 100–240 V) in a power socket complying
with the appliance specifi cations.
♦ The charging progress is indicated by the charging indicator lamp 4 .
– charging indicator lamp fl ashes red: the battery is discharged
– charging indicator lamp illuminates red: battery is being charged
– charging indicator lamp illuminates green: battery is fully charged
♦ Once the battery is fully charged, you can use the appliance for around 60 minutes without
connecting it to the power supply.
Operation with the mains power adapter
If your hair and beard trimmer stops working during shaving due to a discharged or weak battery,
you can continue shaving by plugging in the mains power adapter
6 .
♦ Plug the mains power adapter plug 6 into the socket on the underside of the hair and beard
trimmer.
♦ To avoid injuries and damage to the appliance, always switch the appliance off before con-
necting it to the power supply.
♦ Plug the mains power adapter 6 (wide-range voltage 100–240 V) in a power socket complying
with the appliance specifi cations.
♦ After 1–2 seconds, you can switch the appliance on by pressing the ON/OFF switch 3 .
If the appliance does not start immediately, switch it off again and wait around 1 minute
before switching it on again.
♦ If you want to charge the battery without using the charging station 5 in this manner you can
only do this when the appliance is switched off .
IB_96126_SHBS5A1_LB4.indb 9 IB_96126_SHBS5A1_LB4.indb 9 21.01.14 15:16 21.01.14 15:16