Silvercrest SHBS 5 A1 - Manual (Page 14)

11 SHBS 5 A1
GB
Comb attachment for the beard trimmer attachment
The comb attachment 12 has settings for 6 diff erent cut lengths (4 mm/6 mm/9 mm/12 mm/
15 mm/18 mm).
♦ Attach the comb attachment 12 from the front onto the beard trimmer attachment 7 and press
it down.
♦ To remove the comb attachment 12 press it forwards off the appliance.
Hair trimmer attachment
NOTE
► Any hair to be cut should be clean and dry.
► Brush the hair carefully through to remove any knots.
► Place a hairdressing cape or cloth around your neck and throat to avoid cut hair ends
falling inside your collar.
► Start by setting the comb attachment 11 to a longer length and reduce this in stages while
cutting the hair.
► Please note that the corresponding cut length will only be achieved if the slide switch 2
is set to position 3 and the appliance is being held at right angles to the skin surface.
♦ Switch the hair and beard trimmer on by pressing the ON/OFF switch 3 .
♦ Run the hair and beard trimmer slowly through your hair.
♦ Hold the appliance so that the comb attachment 11 is as fl at as possible.
♦ Always cut from your neck towards the top of your head, or from your forehead and temples
upwards towards the middle of your head.
♦ Use the hair trimmer attachment without the comb attachment 11 to cut the hair very short.
♦ You can use the slide switch 2 to fi nely adjust the cut length in three steps.
IB_96126_SHBS5A1_LB4.indb 11 IB_96126_SHBS5A1_LB4.indb 11 21.01.14 15:16 21.01.14 15:16