Silvercrest SHBS 5 A1 - Manual (Page 17)

14 SHBS 5 A1
GB
Cleaning the shaver attachment
CAUTION
Possible damage to the appliance.
► Do not remove the shaving foil from the foil holder and do not clean this with the cleaning brush.
♦ Remove the shaver attachment 10 from the appliance.
♦ Press the buttons at the side of the shaver attachment 10 and pull off the shaving foil holder.
Hold the shaving foil holder only by the sides and do not press on the foil itself.
♦ Clean the cutting blades with the supplied cleaning brush.
♦ Clean the shaving foil in the shaving foil holder by holding it under running water and allow
it to dry off completely before reattaching it to the shaver attachment
10 .
♦ Replace the shaving foil holder onto the shaver attachment 10 . During replacement ensure that
the fi xing tabs on the shaving foil holder are inserted into the corresponding openings on the
shaver attachment
10 , and then press the shaving foil holder gently down until it audibly clicks
into place.
NOTE
► Every now and again, apply a couple of drops of blade oil (accessory) between the blades,
and then distribute it evenly. Attach the shaver attachment
10 to the appliance and allow the
appliance to run for a few seconds without using it. Wipe off any access oil with a soft cloth.
Cleaning the ear/nose hair trimmer attachment
♦ Remove the ear/nose hair trimmer attachment 9 from the appliance.
♦ Clean the ear/nose hair trimmer attachment 9 under running water and allow it to dry
completely before using it again.
IB_96126_SHBS5A1_LB4.indb 14 IB_96126_SHBS5A1_LB4.indb 14 21.01.14 15:16 21.01.14 15:16