Silvercrest SHBS 5 A1 - Manual (Page 13)

10 SHBS 5 A1
GB
Oiling the cutting attachments
We recommend that you oil the hair trimmer , beard trimmer 7 and precision trimmer attach-
ments 8 before fi rst use and after cleaning to ensure full mobility.
♦ To do this, simply apply a couple of drops of blade oil (accessory) between the blades, and
then distribute it evenly.
♦ Wipe off any access oil with a soft cloth. Use only non-corrosive oils such as sewing machine oil.
Handling and use
Attaching/changing the cutter attachments
WARNING
► Switch off the appliance before attaching or changing the cutter attachments.
There is a risk of personal injury!
♦ Press your thumbs forwards against the cutter attachment to release it from its holder
(see Fig. D). Then remove the cutter attachment from the appliance.
♦ To attach the cutter attachment, insert the lower plug-in tab into the opening on the appliance
(see Fig. E).
♦ Then press the upper part of the cutter attachment onto the appliance until it audibly clicks into
place and is fi rmly seated (see Fig. F).
Attaching/changing the comb attachments
Comb attachment for the hair trimmer attachment
The comb attachment 11 has settings for 6 diff erent cut lengths (13 mm/15 mm/17 mm/
19 mm/21 mm/23 mm).
♦ Attach the comb attachment 11 from the front onto the hair trimmer attachment and press
the rear end fi rmly until it clicks into place.
♦ To remove the comb attachment 11 , release the lower end and pull it forwards off the appliance.
IB_96126_SHBS5A1_LB4.indb 10 IB_96126_SHBS5A1_LB4.indb 10 21.01.14 15:16 21.01.14 15:16