Extreme Networks Summit 300-48 - Manual (Page 80)

80 Summit 300-48 Switch Software User Guide
Wireless Networking
Table 25 lists the configuration commands for wireless ports.
Managing Wireless Clients
Table 26 lists the commands for configuring interactions with client stations.
Show Commands
Use the show commands listed in Table 27 to display information on port configuration, RF profiles,
security profiles, and stations.
Table 25: Wireless Port Interface Configuration Commands
Command Description
config wireless ports <portlist> interface [1 | 2] rf-profile
<name> Attaches the port in the port list to the named RF
profile. All ports in the port list must have the same
wireless port version.
config wireless ports <portlist> interface [1 | 2]
security-profile <name> Attaches the ports in the port list to the named
security profile. All ports in the port list must have
the same wireless port version.
config wireless ports <portlist> interface [1 | 2] channel Configures a channel for the specified interface.
Default is
Auto for both interfaces.
config wireless ports <portlist> interface [1 | 2]
power-level Configures the power level for the specified
interface (full, half, min, one-eighth, quarter).
Default is
full .
config wireless ports <portlist> interface [1 | 2]
transmit-rate Configures a transmission rate for the specified
port. Choice of rates depends upon the mode of the
interface (A or G). Default is
54Mbps .
enable | disable wireless ports <portlist> interface [1 | 2] Enables or disables the specified port interface.
reset wireless ports <portlist> interface [1 | 2] Forces the wireless port interface to reset.
Table 26: Client Configuration Commands
Command Description
show wireless ports <portlist> interface [1 | 2]
clients {detail} Shows wireless client status.
show wireless ports <portlist> interface [1 | 2]
pae-diagnostics Lists EAP diagnostics for the selected port and
interface.
show wireless ports <portlist> interface [1 | 2]
pae-statistics Lists EAP statistics for the selected port and
interface.
Table 27: Show Commands
Command Description
show wireless ports <portlist> interface [1 | 2] rf-status
{detail} Lists data rates, and ESS name for the selected
port and interface.
show wireless ports <portlist> interface [1 | 2]
security-status {detail} Lists WEP, authentication, dot1x, and guest mode
information for the selected port and interface.
show wireless config Lists the country, type of management access,
management VLAN, and gateway.