Extron electronic 6400s - Manual (Page 34)

Programmer’s Guide, cont’d
Matrix 3200/6400 Series • Programmer’s Guide 4-2
Programmer’s Guide
Serial Communications Port
If the Matrix 6400 Audio Switcher is the Master BME (BME #0), its RS-232/RS-422
connector may be connected to the serial port output of a Host device such as a
computer or control panel. Software control of the switcher is made possible by this
connection. A Host serial port connection to the RS-232/RS-422 connector of a
Matrix 6400 Audio Switcher is shown in Figure 4-1.A.
The Matrix 6400 Audio Switcher is normally configured for RS-232 control. If
it is to be used with an RS-422 device, an internal cable must be moved. The
procedure for moving the cable begins on Page 5-2.
The RS-232/422 connector on the Matrix 6400 Audio Switcher is a 9-pin
D female with the following pin assignments:
Pin RS-232 Description RS-422 Description
1 – not used Tx(-) Transmit Data (-)
2 Tx Transmit Data Tx(+) Transmit Data (+)
3 Rx Receive Data Rx(+) Receive Data (+)
4 – not used Rx(-) Receive Data (-)
5 Gnd Signal Ground Gnd Ground
6 – not used – not used
7 – not used – not used
8 – not used – not used
9 – not used – not used
The protocol is 9600 baud, 8-bit, 1 stop bit, no parity and no Flow control.
Details for programming the Matrix 6400 Audio Switcher from a Host system
connected to the RS-232/RS-422 port are covered in this chapter.
Figure 4-1.A Matrix 6400 Audio Switcher RS-232/RS-422 to Host
connection
To Host
System/Device
Serial Port
Male
Connector
1
5
6
9
AN AH EIM , C A MA DE IN U SA
AC PO WER INPUT FUSE: 250V 5.0A
TT
100-240V 0.5A MAX 50/60Hz DISCONNECT PO
WER CORD BEFORE SER
VICING
BM E
AD DR ES S
4
IN
OUT
BME COMM.
MKP COMM.
A B C D E A B C D E
IN
1 - 8
IN
9 - 16
IN
17 - 24
IN
25 - 32
IN
33 - 40
IN
41 - 48
IN
49 - 56
IN
57 - 64
OUT
1 - 8
OUT
9 - 16
OUT
17 - 24
OUT
25 - 32
OUT
33 - 40
OUT
41 - 48
OUT
49 - 56
OUT
57 - 64
INPUTS
OUTPUTS
Female
Connector
1
5
6
9