Extron electronic 6400s - Manual (Page 42)

Programmer’s Guide, cont’d
Matrix 3200/6400 Series • Programmer’s Guide 4-10
S WITCHER G ENERATED U NSOLICITED R ESPONSES
When a local event takes place, such as a Front Panel operation, the switcher responds by sending an
unsolicited response (message) to the Host. These switcher initiated messages are listed below.
RECONFIGØØ = Audio level change
RECONFIGØ2 = Room#1 or room#1’s preset name change
RECONFIGØ3 = Room#2 or room#2’s preset name change
RECONFIGØ4 = Room#3 or room#3’s preset name change
RECONFIGØ5 = Room#4 or room#4’s preset name change
RECONFIGØ6 = Room#5 or room#5’s preset name change
RECONFIGØ7 = Room#6 or room#6’s preset name change
RECONFIGØ8 = Room#7 or room#7’s preset name change
RECONFIGØ9 = Room#8 or room#8’s preset name change
RECONFIG1Ø = Room#9 or room#9’s preset name change
RECONFIG11 = Room#1Ø or room#1Ø’s preset name change
RECONFIG12 = Name change for global preset #1-16
RECONFIG13 = Name change for global preset #17-32
RECONFIG14 = Current connection change
RECONFIG17 = Name change for virtual input #1-16
RECONFIG18 = Name change for virtual input #17-32
RECONFIG19 = Name change for virtual input #33-48
RECONFIG2Ø = Name change for virtual input #49-64
RECONFIG21 = Name change for virtual output #1-16
RECONFIG22 = Name change for virtual output #17-32
RECONFIG23 = Name change for virtual output #33-48
RECONFIG24 = Name change for virtual output #49-64
RECONFIG25 = Individual mute change
RECONFIG26 = RGB->SYNC delay change
RECONFIG34 = A global preset has been saved
RECONFIG35 = A room preset has been saved
RECONFIG36 = All RGB Sync Delays initialized (Zapped to Ø sec)
RECONFIG37 = All Audio Levels initialized (Zapped to Ø dB)
RECONFIG38 = All Mutes initialized (Zapped to UnMuted)
RECONFIG4Ø = Global mute change
RECONFIG41 = Power supply status changed
RECONFIG99 = Entire System initialized (Master Reset)