Elmo PTC-200C - Manual (Page 15)

- 14 -
[1] Power supply to the Camera
The Camera has no POWER switch. Power is supplied to the Camera when the AC
adapter is connected to the wall socket and the Camera.
When power is supplied to the Camera, the Camera turns to the right and then to the
center automatically (viewed from the front), returning the Camera position to the
detault home position.
4. OPERATION PROCEDURES
(1) Turning OFF the Camera
• When the Camera is ready for operation
through the wireless remote control and
POWER button is pressed, the Camera
power is turned OFF. (However, even after
the Camera is turned OFF, power is still
being supplied to the Camera as power
supply to the Camera is not OFF.)
• The image disappears, and the LED on the
Camera lights up in red. Now, no buttons on
the wireless remote control are functional
1
[2] Turning ON/OFF of the Camera power
1
17
other than POWER button and ID button.
• When the TIMER OFF function is ON (refer to the settings in the OSD Menu screen),
Camera power is turned OFF automatically upon the lapse of the set time.
Note: When the Camera is not in use, make it a rule to keep the Camera
OFF. This will save power consumption. When the Camera is not to
be used for a long time, it is advisable to unplug the AC adapter to
render the Camera OFF.
(2) Turning ON the Camera
• When the Camera is OFF and POWER button is pressed, the Camera power is
turned ON.
• The image appears, and the LED on the Camera goes out. Now, the Camera is ready
for operation of all functions through the wireless remote control.
• If the ID number is changed (Refer to "5. THE ID NUMBER SETTING" on P.18), the
Camera power may not be turned ON. In such case, redo the ID number setting, and
press POWER button. 1
1
17 1