Elmo PTC-200C - Manual (Page 18)

- 17 -
[5] BLC (Back Light Control)
In case the back lighting is too bright to shoot the
main object clearly, press BACK LIGHT
button.
To cancel this mode, press the button.
14
[6] Preset operation
The Camera head direction, the zoom position, the
focus status and the brightness level can be
registered for as many as six settings.
The registration contents will be retained even if
the Camera power is turned OFF.
(1) Setting presets
• Set the Camera head direction, the zoom
position, the focus status and the brightness
level.
• When PRESET button is pressed, the
LED on the Camera blinks in green (for 0.4
16
14
16
18
sec). To cancel this, press PRESET button again.
• Then, press one of the 1 through 6 buttons. Now, the registration is over, and
the LED on the Camera goes out. (The preset contents, if already registered, are
erased and overwritten.)
(2) Execution of preset
• When one of the 1 through 6 buttons are pressed, the Camera head direction,
the zoom position, the focus status and the brightness level are set to that specific
preset position.
18
18
16