Marshall Electronics MXL Genesis SE - Manual (Page 4)

The front of the microphone is always indicated by the position
of the cardioid pattern symbol.
3
condensation from one’s breath
and protects and protects the
microphone’s capsule from moisture
in the process. Condensation on
the microphone’s capsule will cause
the microphone to short circuit -
resulting in the microphone cutting
in and out of operation. Should this
occur, you can leave the microphone
uncovered, out in the open
for approximately two weeks to
thoroughly dry. This will likely
rectify the problem. Afterward, you
should always use a pop filter.
Shockmount
The Genesis-SE comes with a
custom shockmount specifically
designed to handle its large
size. Shockmounts de-couple the
microphone from the mic stand and
the environment. The shock-mount
will minimize floornoise as well
as any noise induced by people
handling the microphone stand.
Shockmounts should be considered
“standard equipment” for all
recording applications.
Microphone Cables
The microphone cable can have a
profound effect on the sound of
any microphone. Even the finest
microphones will sound poor if the
interconnect cable allows noise to
enter, or causes distortion and
loss of information. We highly
recommend exclusively using the
Mogami ® cables supplied with
your Genesis-SE Mic.
Continued from page 2
Accessories
8
Front Panel Placement: For the upper strings, position the microphone
approximately 8 - 11 inches away from the strings, with the Pan position set
to left of center. For the lower strings, position the microphone 8 - 11 inches
away from the strings, with the Pan position set to right of center.
(see Fig. 4B)
Single Microphone / Open Top: If you are using a single microphone, it is
generally recommended that you record from above, as placement of the
microphone in the lower center may interfere with the performer’s ability to
access the pedals and the microphone will likely pick up excessive pedal
and other mechanical noise. Position the microphone just over the open top,
centered over the instrument. (see Fig. 4C)
Fig. 4B
2 1
Front Panel Removed
Front View
Mics positioned
8-11” away from strings
Side View
Fig. 4C
1 1 Side View Front View