Meliconi Gumbody Universal 6 Light User Manual
Page 2
9
To programme the
U N I V E R S A L 6 L i g h t
remote control,
follow the indications in paragraph
A
,
B
or
C
.
The quickest and easiest way to programme the remote control is by
consulting the website
www.gumbodylight.com
.
Warning:
programme one appliance at a time!
BRAND SEARCH PROGRAMMING MODE
A
F I T T I N G T H E B A T T E R I E S
Before programming and using
the remote control, fit the batteries.
The remote control requires 2 new AA/LR06 batteries. Insert the batteries as shown:
• Change the batteries if the light indicator starts to flash
during use. The batteries are low.
• Make a note of the codes for your appliances on the
adhesive label inside the battery cover in case you have
to reprogramme your remote control.
• This remote control has a permanent memory and does
not lose the programmed codes or functions when the
batteries are removed.
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
ADDITIONAL CHECK
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from point 3, entering the code
previously used (e.g. 0025).
+
+
+
1. Turn on the appliance to be programmed:
- if a VCR, insert a cassette
- if a SAT or TER select a programme
- if a DVD insert a DVD.
2. Look for the brand of the appliance you want to programme
in the code book and make a note of the code indicated
alongside (
e.g. PHILIPS 0025) or the code for the brand
indicated by the arrow.
3. Hold down the selection key for the appliance to be
programmed for 5 seconds.
4. When the key is released, it will start to flash. Enter the
brand code previously identified (
e.g. 0025). The selection
key flashes more quickly to indicate that the remote
control is ready for the search.
5. Point the remote control at the appliance. Press and slowly
release the ON/OFF key or PLAY for the VCR and DVD
several times, stopping when the appliance responds
correctly to the command.
6. When the appliance responds correctly, press OK to
confirm. Three flashes indicate that the search operation
has been completed correctly.
PHILIPS
0025
PHONOLA
PHILIPS
or
5 SEC.
or
or
or
or
or