Meliconi Gumbody Universal 6 Light - Manual (Page 3)

10
1. Turn on the appliance to be programmed:
- if a VCR, insert a cassette
- if SAT or TER select a programme
- if a DVD insert a DVD.
2. Look for the brand of the appliance you want to programme
in the code book and make a note of the first code in
the list (
e.g. Philips TV 1000 - VCR 5070).
3. Hold down the selection key for the appliance to be
programmed for 5 seconds.
4. When the key is released, it will start to flash. Enter the
previously identified code ( e.g. 1000). Three flashes
indicate that the code has been memorized correctly. If
not, try the code entry procedure again from point 3.
PHILIPS 0025
TV 1000 1006 1007 1008
1009 1010 1011 1012 1013
1014 1015 1016 1017 1018
VCR 5070 5072 5073 5076
N.B. THE LIGHT INDICATOR STOPS FLASHING.
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid brand code is entered
• if a key other than ON/OFF or PLAY is accidentally pressed
• if the end of the code search list has been reached. In this case, go back to point or switch
to programming mode .
C
D I R E C T C O D E E N T R Y
B
The quickest and easiest way to programme the remote control is by
consulting the website www.gumbodylight.com .
Warning: programme one appliance at a time!
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
C
This operation can take up to 20 minutes and should be carried out if you have not
succeeded in programming the remote control by means of the other methods.
The quickest and easiest way to programme the remote control is
by consulting the website www.gumbodylight.com .
Warning: programme one appliance at a time!
Remember to make a note of the codes used to programme the remote control on the adhesive
label inside the battery cover for quick and easy reprogramming.
N.B. THE LIGHT INDICATOR STOPS FLASHING.
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid code is entered
• if the wrong keys are accidentally pressed.
ADDITIONAL CHECK
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably used the wrong code. In this case, repeat
the procedure starting from point 3. This time, however, use the NEXT CODE in the list (e.g. Philips TV
1006 – VCR 5072).
+ + + 1 0 0 0
1. Turn on the appliance to be programmed:
- if a VCR, insert a cassette
- if SAT or TER select a programme
- if a DVD insert a DVD.
5 SEC. or or or or or