Rose Electronics ViewLink CATx - Manual (Page 11)

VIEWLINK CATX INSTALLATION AND OPERATIONS MANUAL 5
Installing the Video only model -
For the Video only model, connect the transmitter’s HD15M connector to the
HD15F video out connector on the PC. Connect the transmitter’s USB cable to the
computers USB port. The USB cable provides power only to the transmitter.
Connect the receiver’s HD15F connector to a video monitor and connect the power
adapter. If a USB port is not available, Rose Electronics can provide a special cable to
connect to transmitter to a power adapter. See part number table.
NOTE: The USB ports on the receiver are for connecting a USB keyboard to perform
video adjustments only. (Commands shown on page 5)