Eiki 8080 - Manual (Page 10)

Basic Operation
10
Basic Operation and Connection
4
Selecting the input
To listen to a CD, set the [CD/USB] Input Select switch to “CD.” To listen to an audio file
on the USB flash drive, set the [CD/USB] Input Select switch to “USB.”
The corresponding (CD or USB) transport controls (see page 13) become active.
To record audio from a cassette tape to a connected USB flash drive, set this switch to
“USB.”
CAUTION:
• The cassette tape transport controls have the highest priority. consequently, during playback of a cassette tape, you
cannot play a CD or an audio file on the connected USB flash drive.
1
Adjusting the tone
In most cases, set
the [TONE] knob to
“HIGH,” which is the
standard setting.
If you want to cut
some high fre-
quency range or
reduce hiss, rotate the knob counter-
clockwise.
* “Hiss” is high frequency noise that is often
present on analogue magnetic tape recordings.
2
Adjusting the left and right
level balance
In most cases, set
the [BALANCE]
knob to the center.
Turning the knob
counter-clockwise
pans the sound to
the left in the ste-
reo image, and turning it clockwise
pans the sound to the right.
3
Adjusting the volume
Rotate the [VOL-
UME] knob clock-
wise to raise the
volume, or counter-
clockwise to lower
the volume.
CAUTION:
• If the volume level is too high,
the sound may be distorted or
the speakers may be dam-
aged. Adjust the volume care-
fully.
DIGITAL DISPLAY
REPEAT 1ALL REMAIN
TRACK NO. TIME
MIN. SEC.
RANDOM
PROGRAM
MEMORY
AUTOMATIC STOP
2 x COUNTER
PUSH
OPEN
VARIABLE PITCH CONTROL
25 RANDOM ACCESS PROGRAM
1 2 3 4
56
8
7