EZQuest DVD Duplication - Manual (Page 47)

Troubleshooting
6.1 About LCD
After powering on if there is no LCD, please check if the connection of power cord
is frim and the environment of power outlet is normal.
6.2 About Error Messages
During Copy, Test, Compare and Verify, etc. if you press ESC to abort, an error
message will appear on LCD. Abortion may cause the copy smart plus to hang up,
therefore you have to power on again.
If reading fails, an error message will appear on LCD. Please get a new source DVD
to try again.
If the copy smart plus hasnít detected any device after powering on, an error message
will appear on LCD.
6.3 About DVD-ROM/DVD Writers
If a DVD-ROM or DVD writers cannot read, please confirm the format of the
source DVD and check if it is damaged.
Use any DVD writer to read the source DVD. If it works, the DVD-ROM is probably
defective or not compatible with the source DVD.
Use a fine DVD writer as the data reader, and set the ìRead Speedî at minimum.
Page 47