Exabyte EXB-8205 - Manual (Page 16)

5. Slide the tape drive into the drive bay and secure
the drive to the bay as instructed in you computer
system documentation.
6. If you needed additional chassis grounding,
connect a
1 ⁄
4 -inch female spade connector to the
ground tab at the rear of the tape drive. Or, connect
an M3-0.5 6 mm self-tapping screw to the
grounding hole. The ground tab and grounding
hole are shown in Figure 7.
Note: The power supply returns are connected to
the chassis, so you cannot isolate logic
common ground from chassis ground.
Figure 7 Location of ground tab, grounding hole, and
power connector on the back of the CTS
16 EXB-8205 and EXB-8505 (Standard and XL) 302967