Exabyte EXB-8205 - Manual (Page 41)

Chassis Grounding (Optional)
If you needed additional chassis grounding, connect a
1 ⁄
4 -inch female spade connector to the ground tab at the rear
of the tape drive. Or, connect an M3-0.5 6 mm self-tapping
screw to the grounding hole. The ground tab and grounding
hole are shown in Figure 7 on page 16.
Note: The power supply returns are connected to the
chassis, so you cannot isolate logic common
ground from chassis ground.
May 1994 EXB-8205 and EXB-8505 (Standard and XL) 41