Euphonix MC Control - Manual (Page 19)

professional control surface
Artist Series
USER GUIDE
SETUP AND INSTALLATION
19
6. Plug one end of the Ethernet crossover cable into the Ethernet jack (labeled
with
) on the rear panel of the MC Control (Figure 2-8).
Figure 2-8 Ethernet cable and rear panel jack
7. Plug the other end of the Ethernet crossover cable into an open Ethernet
jack on your computer, router, or Ethernet switch (Figure 2-9).
An Ethernet router or switch is required to connect additional MC Mixes or
to a local area network. Note that connecting directly to the computer (Fig-
ure 2-9-right) may require removing your Internet cable.
If you have a Mac with two Ethernet ports, use Ethernet 1, not Ethernet 2.
Figure 2-9 MC Control connected to router (left) and directly to computer (right)
8. Turn on your router (if applicable), then turn on your Mac and wait until it
finishes starting up.
Eu con
Ethernet
cable