Amprobe THWD-10 THWD-10W RH-Meters - Manual (Page 14)

7
“SAVE” Button
The save function stores the %RH, K-TYPE, NTC, Wet
bulb, Dew point data in a nonvolatile memory. Press the
“SAVE” key to save the current data, the word SAVE is
displayed to indicate the data are saved. The build in
memory can store up to 256 data.
“READ”, “p”, “q” Button
To recall the readings from memory, press “READ” key.
To check the memorized data just to press “p” or “q”
until the desired memorized data is displayed. To return
the meter to normal operation, press “READ” key again.
* CLR SAVE DATA:
Pressing the “p” key for more than 5 seconds to clears
all the saved data in memory. And lower display show
“Clr” about 2 second.
Wireless Mode: (THWD-10W)
Press the “ ” key for more than two seconds to start
wireless function. Press the “ ” key again for another
two seconds to stop wireless function. The wireless mode
will shut down if there is no wireless signal for two
minutes.
To SET CH/ID to 00,00, press the “q” key and “ ”
power key for more than 6 seconds with the meter
powered down. The meter will set channel and ID to
00,00 status. The second display will show 00, which
means that the channel and ID has been set to 00.
To check the channel and ID of the meter
When the meter is off, press “°C/°F” key and “ ” for 5
seconds, LCD’s main display will show channel number,
the second display will show ID number.