PLANET XGS3-24040 - Manual (Page 276)

17-34
Usage Guide:
None.
Example:
Configure tunnel destination 203.78.120.5.
Switch(Config-if-Tunnel1)#tunnel destination 203.78.120.5
17.2.40 tunnel nexthop
Command:
tunnel nexthop <ipaddress>
no tunnel nexthop <ipaddress>
Function:
Configure tunnel next hop.
Parameter:
<ipaddress> is the ipv4 address of tunnel next hop.
Command Mode:
Tunnel Configuration Mode.
Default Situation:
None.
Usage Guide:
This command is for ISATAP tunnel, other tunnels won’t check the configuration of nexthop.
Example:
Configure tunnel next hop 178.99.156.8.
Switch(Config-if-Tunnel1)#tunnel source 178.99.156.7
Switch(Config-if-Tunnel1)#tunnel nexthop 178.99.156.8
Switch(Config-if-Tunnel1)#tunnel mode ipv6ip isatap
17.2.41 tunnel 6to4-relay
Command:
tunnel 6to4-relay <ipdaddress>
no tunnel 6to4-relay <ipdaddress>
Function:
Configure the 6to4 tunnel relay IPv4 address.
Parameters:
<ipdaddress>is the 6to4 tunnel relay IPv4 address.
Command Mode:
Tunnel Configuration Mode.
Default:
None.
Usage Guide:
This command is used to configure the 6to4 tunnel relay IPv4 address, which will not be checked