PLANET XGS3-24040 - Manual (Page 497)

34-210
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: None.
Example:
Switch#debug ipv6 ospf redistribute message send
34.14 debug ipv6 ospf redistribute route receive
Command: debug ipv6 ospf redistribute route receive
no debug ipv6 ospf redistribute route receive
Function: To enable/disable debugging of received routing message from NSM for IPv6 OSPF process.
Parameter: None.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: None.
Example:
Switch# debug ipv6 ospf redistribute route receive
34.15 debug ipv6 ospf route
Command: [no] debug ipv6 ospf route [ase|ia|install|spf]
Function: Open debugging switches showing OSPF related routes; the “[no]debug ipv6 ospf route
[ase|ia|install|spf]” command closes this debugging switch.
Default: Closed.
Command Mode: Admin mode
34.16 ipv6 ospf cost
Command: ipv6 ospf cost <cost> [instance-id <id>]
no ipv6 ospf <cost> [instance-id <id>]
Function: Specify the cost required in running OSPF protocol on the interface; the “no ipv6 ospf cost
[instance-id <id>]” command restores the default value.
Parameter: <id> is the interface instance ID, ranging between 0~255, defaulted at 0
<cost > is the cost of OSPF protocol ranging between 1~65535.
Default: Default OSPF cost on the interface is 10.
Command Mode: Interface Configuration Mode.
Usage Guide: The command can configure on IPv6 tunnel interface, but it is successful configuration to
only configure tunnel carefully.