PLANET VIP-281SW - Manual (Page 15)

NAT
In this mode, the device is supposed to connect to internet via
ADSL/Cable Modem. The NAT is enabled and your PC in LAN port
shares the same IP to ISP through WAN port. The connection type
can be setup in WAN page by using PPPOE, DHCP client, PPTP
client, static IP or L2TP.
Bridge
In this mode, all Ethernet ports are bridged together and NAT function
is disabled. All the LAN port related function and firewall are not
supported.
Wireless ISP
In this mode, all Ethernet ports are bridged together and the wireless
client will connect to ISP access point. The NAT is enabled and PCs in
Ethernet ports share the same IP to ISP through wireless LAN. You
must set the wireless to client mode first and connect to the ISP AP in
Site-Survey page. The connection type can be setup in WAN page by
using PPPOE, DHCP client, PPTP client, static IP or L2TP.
WAN Interface Setup
This page is used to configure the parameters for Internet network which connects to the WAN port of
your Gateway. Here you may change the access method to static IP, DHCP, PPPoE, PPTP or L2TP by
click the item value of WAN Access type.
- 15 -